Sponsored by Pickering Interfaces. Applications for 10GBASE-T1 MEMS Fault Insertion. As EV architectures evolve to support ADAS, autonomy, and high-bandwidth in-vehicle communications, validating 10GBASE-T1 Automotive Ethernet links is becoming increasingly complex. This white paper explores how automated MEMS-based fault insertion can help test engineers move beyond time-consuming road testing and simulate real-world connectivity faults in… Read more »
Sponsored by TTI & TE Connectivity. Automotive consumers demand more personalization, autonomy and connectivity from their driving experience. To make this a reality, connectivity plays a pivotal role in vehicle innovation design requirements. The next generation of vehicles needs more cameras to support advanced driver-assistance system (ADAS) and autonomous driving (AD) functionalities. The cameras need to be… Read more »
Sponsored by Churod Electronics. Increased battery density is the endgame of all cutting-edge battery design, improvements cannot come at the expense of safety or cost limitations. The question then becomes how to push the envelope in a safe and cost-effective way. Monitoring the state-of-health of cells is at the top of the list of considerations. Accurately… Read more »
Sponsored by Heraeus Electronics. The electric vehicle market is emerging as a leading field for advanced heating technologies. In EVs, heating systems are essential not only for passenger comfort but also fundamental to thermal management, keeping battery cells within their optimal temperature range in cold climates. Proper thermal control enables faster and more efficient charging,… Read more »
As EV battery systems evolve towards higher voltages, greater energy density, and more demanding safety requirements, traditional isolation approaches are increasingly challenged during severe fault events. When short circuits, crashes or control system failures occur, protection systems must respond in milliseconds to prevent escalating risks. In this webinar, Sensata will explore how active and passive… Read more »
In this webinar, we’ll discuss laser welding process strategies for battery and power electronics applications. From busbars, tabs to terminals and power-module interconnects, the session will explore a range of topics covering weld geometry, metallurgy, penetration control, fixture and clamping considerations, inline monitoring, and process validation using real application examples and cross-sectional analysis. The webinar… Read more »
Sponsored by Chroma. Lithium-ion batteries face increasingly severe challenges regarding safety and lifespan under high-rate charging. One of the most critical concerns is the phenomenon of lithium plating—when the charging current is too high or the temperature is too low, lithium-ions fails to intercalate effectively into the anode and instead deposit as metallic lithium on… Read more »
Sponsored by Parker. A key to the advancement of high energy-density, lithium-ion, battery packs is effective management of heat generated during charge and discharge cycles. Heat is often managed by connecting battery cells and/or modules to a cooling plate or pack via thermally conductive materials (gap fillers or adhesives). Typically, they are two-component polymeric resins… Read more »
Sponsored by Avery Dennison Performance Tapes. Intended for engineers and decision-makers in the EV battery design, manufacturing and implementation, the new “EV battery electrical insulation design guide” from Avery Dennison Performance Tapes, helps readers understand and make informed choices about using dielectric tapes as an electrical insulation solution. Featuring the Volt Tough™ portfolio of electrically… Read more »
Sponsored by ITECH. As EV platforms push from 400 V to 800 V and beyond 1000 V, engineers are facing a growing gap between charging capability and what can be safely tested in real-world conditions. This whitepaper unpacks the concept of “validation anxiety” and the risks tied to reliability, lifecycle performance, and grid interaction. It… Read more »
